FM860-LA-000 - Modbus stepper driver

MODBUS RS485 communication interface
Power supply 24 to 70VDC
6 opto-isolated inputs
3 opto-isolated outputs
1 analog input ±10V
Homing function, Multi-speed, Multi-position

167.00 € Without Taxes 167.0 EUR 167.00 €

167.00 €

200.40 € 200.40 € with taxes

  • Brand
  • Axes
  • Inputs
    • 6
  • Outputs
    • 3
  • Analog inputs
  • Min. Voltage
  • Max. Voltage
  • Max. current
  • Interface

This combination does not exist.

En rupture de stock

Product Documents

Manuel FM860-xA
Logiciel de paramétrage KincoStep V1.6
You have to login to access this document.

Internal Reference: FM860-LA-000

The FM860-LA-000 driver is a stepper motor driver equipped with a MODBUS protocol communication interface.

Compatible with 2-phase bipolar stepper motors and also with 3-phase motors.

Control can be done by RS485 bus, MODBUS protocol, by a Step/Direction command and also by an analog input +/-10V You have several operating modes:

  • The multi-position mode which allows using a combination of inputs, to select different positions,
  • The multi-speed mode which allows using a combination applied to the inputs, to select a rotation speed,
  • Homing mode, which allows you to perform an origin cycle based on the detection of a limit switch.

Specs:

  • Power supply 24 to 70VDC
  • Compatible with 2 or 3 phase stepper motors,
  • Output current from 0.1A to 6A
  • 6 optocoupled inputs (including 3 inputs accepting voltages from 5 to 24VDC)
  • 3 optocoupled outputs (100mA max)
  • 1 analog input +/-10V
  • Different pulse control modes: Pules/Dir, CW/CCW or quadrature
  • Full step resolution to 1/128 step
  • Over voltage, low voltage, over temperature and over current protection.
  • Wheight 0.36Kg




Accessories

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.

Specifications

Brand Kinco
Axes 1 Axe
Inputs 6
Outputs 3
Analog inputs 1
Min. Voltage 24 V
Max. Voltage 70 V
Max. current 6 A
Interface Modbus RS485
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.